Go BottomKubota L295DT 3 point not working
 | bmcbee
Join Date: May 2006 Posts: 2 Kansas City, MO 
|
2006-05-17 129479
I just bought a L295DT with front loader, the hydraulics were slow so I replaced the pump, the PWR steering, loader, and aux hydraulics work great now! But the 3 point won't raise at an idle, you have to rev it about 1/2 way to get it to raise, but won't pick any weight up, the higher you rev it the fast it will go up, but not carry weight. I have an old manual but the blow up of the 3pt internal cylinder is not there. I shimed the check valve, but it didn't help, I am wondering if there is an O-ring in the lift cylinder located in the case under the seat, if so do I have to take the whole top part of the case off? Is it a special O-ring? Any help or suggestions would be terrific!
Reply to |
Quote Reply |
Add PhotoKubota L295DT 3 point not working
| tool_man2
Join Date: May 2006 Posts: 11 ohio
|
2006-05-19 129564
bmcbee,
Sounds like you are on the right track. I'm sure the seal will be metric and could possibly be bought from a seal distributor rather then Kubota. The money saved would be minimul.
Good Luck !
Tool Man ....
Reply to |
Quote Reply |
Add PhotoKubota L295DT 3 point not working
| bmcbee
Join Date: May 2006 Posts: 2 Kansas City, MO
|
2006-05-19 129565
Thanks for the affirmation, I'll likely tear into it this weekend and see if we are right, just always good to hear from someone else that they think I am on the right track!
Have a great weekend and thanks again for your time and suggestion on where to get the seal! ....
Reply to |
Quote Reply |
Add PhotoKubota L295DT 3 point not working
| skidroid
Join Date: Jul 2007 Posts: 1 wyoming
|
2007-07-15 143736
i just bought a Kubota L295DT w/ a 1200 HD Loader.
The loader won't work unless you go full throttle to get it working. once it starts working it works even at idle. any ideas why or possible fix? ....
Reply to |
Quote Reply |
Add Photo
Go Top
Share This